Hi all!
I don't know what they changed, but they released a new firmware upgrade yesterday!
http://www.anycubic3d.com/support/show/594032.html
Firmware_V1.0_20180705
EDIT: FIrmware upgraded. The instructions says
"Please plug the USB into the machine, And switch it on. Then it will read the firmware
automatically and make several sounds like ““di di”"
But I had to "print" the update.LCD file as the update wasn't loaded at start. Now the firmware is installed (v. 4.1.5).
New firmware released
-
- Posts: 2
- Joined: Sun Dec 02, 2018 9:10 am
Re: New firmware released
I upgraded
Load the first file then you need to "print" another two
but since then prints do not finish ?
at approx 95 % just stops and returns to startup screen
anyone else experiencing this ?
Load the first file then you need to "print" another two
but since then prints do not finish ?
at approx 95 % just stops and returns to startup screen
anyone else experiencing this ?
-
- Posts: 6
- Joined: Thu Dec 27, 2018 3:43 pm
- Location: Panama
- Contact:
New firmware released
There is new version of Zfirmware but I dont think its been officially released yet. Martin could send you the link.