i using my 3D printers for remake car parts, mostly oldtimer plastic parts that gone missing or bad over the years. Now i added the Photon to my collection. Has anyone experience with strength/hardness od some resins ? I have a set of gears on a hub, that i printed with filament in PETG (gears) and PLA (Hub's) that worked fine, strong enough. The set is used for mirror adjuistment so it get's a little stress while using. I re-draw the parts because due the accuracy of Photon i could not use the STL's i use for filament printer. Now i notice that with the Anycubic resin the parts are not hard enough, gears are a bit to soft resulting in ot running smooth and wear out in a few turns. Values for Anycubic resin are Strength 79D Tensile 23.4. I also have a bottle of Photocentric firm ( Strength 65D tensile 26 ) so i gonna try that, but that is not gonna help i guess. Also this is water washable and is less accurate. Does somebody know what resin i could try ? Of course i am searching for low cost resin
ps: what is the max upload size for attachements on the forum ?
2 posts • Page 1 of 1