Page 1 of 1

New firmware released

Posted: Fri Jul 06, 2018 10:18 am
by cattivik66
Hi all!
I don't know what they changed, but they released a new firmware upgrade yesterday!
http://www.anycubic3d.com/support/show/594032.html

Firmware_V1.0_20180705

EDIT: FIrmware upgraded. The instructions says
"Please plug the USB into the machine, And switch it on. Then it will read the firmware
automatically and make several sounds like ““di di”"

But I had to "print" the update.LCD file as the update wasn't loaded at start. Now the firmware is installed (v. 4.1.5).

Re: New firmware released

Posted: Sun Dec 02, 2018 9:15 am
by KrankyIguana
I upgraded
Load the first file then you need to "print" another two

but since then prints do not finish ?
at approx 95 % just stops and returns to startup screen

anyone else experiencing this ?

New firmware released

Posted: Sun Dec 30, 2018 9:15 am
by Warnerrerce
There is new version of Zfirmware but I dont think its been officially released yet. Martin could send you the link.